chris b
FLUSH SEWER ,WATERLINES,AND LIGHT WATER HEATER
Answer
I know this is a long answer, but your question warrants it, so here you go...
*Depending on how your unit was winterized it will need to be de-winterized. If you used non-toxic RV antifreeze you need to run fresh water through the entire system until the antifreeze is gone. To remove it from the 12-volt water pump add water to the fresh water-holding tank, turn the pump on and open all of the water faucets. When the antifreeze is out of the system turn the pump off and take the water heater out of the by-pass mode (if applicable). Replace any water filter cartridges you removed for storage.
*At this point I like to sanitize the water system. Make sure all of the drains are closed and drain plugs are installed. Take a quarter cup of household bleach for every fifteen gallons of water your fresh water tank holds. Mix the bleach with water into a one-gallon container and pour it in to the fresh water holding tank. Fill the fresh water holding tank completely full of water. Turn the pump on and run water through each hot and cold faucet, until you smell the bleach. Close the faucets and let it sit for twelve minutes. Drain all of the water and re-fill the tank with fresh water. Turn the pump on and open all faucets until you no longer smell any bleach. It may be necessary to repeat this process to eliminate all signs of bleach.
*With water in the fresh water holding tank turn the 12-volt water pump on and pressurize the water system until the pump shuts off. If the water pump cycles back on, even for a short period of time, there is a leak somewhere. Locate the leak and repair it or take it to an authorized RV service center to be repaired.
*Check the operation of the toilet. Add several gallons of water to the black water holding tank and treat the tank with holding tank chemicals.
*Wash the unit thoroughly. This is a good time to inspect the roof, body seams, and window sealant for cracking that would allow water to get in. Inspect sealants everywhere the manufacturer cut a hole in the RV. Consult a dealer for sealants compatible with these materials.
*Inspect the operation of the awning, clean and check the awning fabric for any damage. Inspect the tires for signs of dry rot. Inflate all tires to the recommended cold tire pressure. Lubricate all hinges and locks with spray lubricant.
*Remove any tape or protective covering you may have put over LP gas vents to keep insects and rodents out. Check any mousetraps you may have put out. Open all doors and compartments and check for rodent intrusion and water damage.
*Inspect and clean the interior of the RV.
*Plug in any appliances that you unplugged for storage and replace any dry cell batteries you may have removed. This is a good time to put new batteries in items like smoke alarms.
*Test the operation of the carbon monoxide detector, LP gas leak detector and smoke alarm.
*Check the fire extinguisher. Be sure it is fully charged.
*Reset any breakers you may have turned off. If you removed any fuses for storage re-install them.
*Clean or replace air conditioner filters if it wasnât done prior to storage and remove any covers that were put over air conditioners.
*Open vents and windows and air the unit out.
*If you removed the coach and chassis batteries for storage install them. Whether they were removed or not check the electrolyte levels, clean the terminals and clamps, and check the state of charge in all batteries. Recharge batteries as necessary.
*Check the operation of the electric steps if applicable. Lubricate step mechanism.
*Test the operation of the hydraulic jacks if applicable. Check hydraulic fluid level.
*Test the operation of the back up camera and monitor if applicable.
*If you didnât change the oil and filters in the generator prior to storage this is a good time to do it.
*Inspect the generator exhaust system for any damage prior to starting it. Start and run the generator for one hour with at least a half rated load on it. Consult the generators owner manual for proper load ratings.
*Turn the generator off and plug the unit in to shore power. Turn the refrigerator on in the electric mode. Allow sufficient time for it to cool and check for proper operation.
*Check all 12-volt interior lights and accessories.
*Test the monitor panel for proper operation.
*Check the operation of slide outs if applicable.
*Check the remaining 120-volt appliances for proper operation.
*Test the Ground Fault Circuit Interrupter (GFCI) for proper operation.
*Turn the refrigerator off, leave the doors open and allow sufficient time for it to get to room temperature so it can be checked in the gas mode.
*Before I use the LP gas system I have a leak test and gas operating pressure test preformed. A qualified technician with the proper equipment should do these tests.
*Turn the LP gas valve on and check the operation of all LP gas appliances. Be sure the water heater is full of water before testing the water heater. If a gas appliance is not operating properly have it inspected by a qualified technician. Insects are attracted to the odorant added to LP gas and build nests that can affect the appliance from operating properly.
*If your unit was in long-term storage and you didnât change the engine oil and filter prior to storage this would be a good time to do it.
*Check all fluid levels in the transmission, power steering, engine coolant, engine oil, windshield washer and brakes. Consult vehicle ownerâs manual.
*Start the engine and check for proper readings on all gauges. Check for proper operation of the dash air conditioner.
*Chassis lubrication should be preformed if it wasnât done prior to storage.
*Check the condition of windshield wiper blades and replace if necessary.
*Check the operation of all chassis lights.
*Make sure the vehicle emissions / inspection sticker is up to date.
In addition to this if you have a pop up or travel trailer the wheel bearings and brakes (if equipped) should be inspected at least once annually. Inspect any canvas for dry rot and tears; inspect all hitch work and the coupler for any damage. Inspect the breakaway switch and pigtail for proper operation. It really doesnât take a lot of time to get your RV ready for another camping season, and you can rest assured that when itâs time to go camping your RV is ready too. Now for the fun part, load your clothes, food, and personal belongings, hit the road and have fun exploring this wonderful country we live in.
I know this is a long answer, but your question warrants it, so here you go...
*Depending on how your unit was winterized it will need to be de-winterized. If you used non-toxic RV antifreeze you need to run fresh water through the entire system until the antifreeze is gone. To remove it from the 12-volt water pump add water to the fresh water-holding tank, turn the pump on and open all of the water faucets. When the antifreeze is out of the system turn the pump off and take the water heater out of the by-pass mode (if applicable). Replace any water filter cartridges you removed for storage.
*At this point I like to sanitize the water system. Make sure all of the drains are closed and drain plugs are installed. Take a quarter cup of household bleach for every fifteen gallons of water your fresh water tank holds. Mix the bleach with water into a one-gallon container and pour it in to the fresh water holding tank. Fill the fresh water holding tank completely full of water. Turn the pump on and run water through each hot and cold faucet, until you smell the bleach. Close the faucets and let it sit for twelve minutes. Drain all of the water and re-fill the tank with fresh water. Turn the pump on and open all faucets until you no longer smell any bleach. It may be necessary to repeat this process to eliminate all signs of bleach.
*With water in the fresh water holding tank turn the 12-volt water pump on and pressurize the water system until the pump shuts off. If the water pump cycles back on, even for a short period of time, there is a leak somewhere. Locate the leak and repair it or take it to an authorized RV service center to be repaired.
*Check the operation of the toilet. Add several gallons of water to the black water holding tank and treat the tank with holding tank chemicals.
*Wash the unit thoroughly. This is a good time to inspect the roof, body seams, and window sealant for cracking that would allow water to get in. Inspect sealants everywhere the manufacturer cut a hole in the RV. Consult a dealer for sealants compatible with these materials.
*Inspect the operation of the awning, clean and check the awning fabric for any damage. Inspect the tires for signs of dry rot. Inflate all tires to the recommended cold tire pressure. Lubricate all hinges and locks with spray lubricant.
*Remove any tape or protective covering you may have put over LP gas vents to keep insects and rodents out. Check any mousetraps you may have put out. Open all doors and compartments and check for rodent intrusion and water damage.
*Inspect and clean the interior of the RV.
*Plug in any appliances that you unplugged for storage and replace any dry cell batteries you may have removed. This is a good time to put new batteries in items like smoke alarms.
*Test the operation of the carbon monoxide detector, LP gas leak detector and smoke alarm.
*Check the fire extinguisher. Be sure it is fully charged.
*Reset any breakers you may have turned off. If you removed any fuses for storage re-install them.
*Clean or replace air conditioner filters if it wasnât done prior to storage and remove any covers that were put over air conditioners.
*Open vents and windows and air the unit out.
*If you removed the coach and chassis batteries for storage install them. Whether they were removed or not check the electrolyte levels, clean the terminals and clamps, and check the state of charge in all batteries. Recharge batteries as necessary.
*Check the operation of the electric steps if applicable. Lubricate step mechanism.
*Test the operation of the hydraulic jacks if applicable. Check hydraulic fluid level.
*Test the operation of the back up camera and monitor if applicable.
*If you didnât change the oil and filters in the generator prior to storage this is a good time to do it.
*Inspect the generator exhaust system for any damage prior to starting it. Start and run the generator for one hour with at least a half rated load on it. Consult the generators owner manual for proper load ratings.
*Turn the generator off and plug the unit in to shore power. Turn the refrigerator on in the electric mode. Allow sufficient time for it to cool and check for proper operation.
*Check all 12-volt interior lights and accessories.
*Test the monitor panel for proper operation.
*Check the operation of slide outs if applicable.
*Check the remaining 120-volt appliances for proper operation.
*Test the Ground Fault Circuit Interrupter (GFCI) for proper operation.
*Turn the refrigerator off, leave the doors open and allow sufficient time for it to get to room temperature so it can be checked in the gas mode.
*Before I use the LP gas system I have a leak test and gas operating pressure test preformed. A qualified technician with the proper equipment should do these tests.
*Turn the LP gas valve on and check the operation of all LP gas appliances. Be sure the water heater is full of water before testing the water heater. If a gas appliance is not operating properly have it inspected by a qualified technician. Insects are attracted to the odorant added to LP gas and build nests that can affect the appliance from operating properly.
*If your unit was in long-term storage and you didnât change the engine oil and filter prior to storage this would be a good time to do it.
*Check all fluid levels in the transmission, power steering, engine coolant, engine oil, windshield washer and brakes. Consult vehicle ownerâs manual.
*Start the engine and check for proper readings on all gauges. Check for proper operation of the dash air conditioner.
*Chassis lubrication should be preformed if it wasnât done prior to storage.
*Check the condition of windshield wiper blades and replace if necessary.
*Check the operation of all chassis lights.
*Make sure the vehicle emissions / inspection sticker is up to date.
In addition to this if you have a pop up or travel trailer the wheel bearings and brakes (if equipped) should be inspected at least once annually. Inspect any canvas for dry rot and tears; inspect all hitch work and the coupler for any damage. Inspect the breakaway switch and pigtail for proper operation. It really doesnât take a lot of time to get your RV ready for another camping season, and you can rest assured that when itâs time to go camping your RV is ready too. Now for the fun part, load your clothes, food, and personal belongings, hit the road and have fun exploring this wonderful country we live in.
Why my fridge dont work?
he_who_squ
My fridge in the rv aint working at all. I checked just bout everything there is to check. But I am thinking that I needa new fridge.
Answer
RV Fridges are usually 3-mode (LP/Electric/Battery). Make sure that it is in the correct mode for what is available. If in LP, you have to have propane in the tank, the tank turned on and the unit must be dead-level. If Electric, mains electric must be connected properly and the breaker for the fridge turned on. If Battery, then there has to be a battery in place with an adequate charge and the change-over switch in the correct position if so-equipped. Further, if in LP, you may have to go through a manual start procedure.
Safety Tip: Don't run a propane appliance of any nature in an RV unless you have both a Carbon-Monoxide detector *AND* an LP Gas-Detector in place and working.
Read the manual for the unit if you can find it.
RV Fridges are usually 3-mode (LP/Electric/Battery). Make sure that it is in the correct mode for what is available. If in LP, you have to have propane in the tank, the tank turned on and the unit must be dead-level. If Electric, mains electric must be connected properly and the breaker for the fridge turned on. If Battery, then there has to be a battery in place with an adequate charge and the change-over switch in the correct position if so-equipped. Further, if in LP, you may have to go through a manual start procedure.
Safety Tip: Don't run a propane appliance of any nature in an RV unless you have both a Carbon-Monoxide detector *AND* an LP Gas-Detector in place and working.
Read the manual for the unit if you can find it.
Powered by Yahoo! Answers
Tidak ada komentar:
Posting Komentar